Can you imagine driving your car and not being able to stop? That's why the brakes are one of the most important parts of a car along with steering and the engine of course. With them being such an important part of the vehicle it is of great importance that they are properly maintained and serviced every few months to ensure they are running to the best of their capability.

Although most people tend to leave their brakes till they have their car serviced it is possible for you to carry out general maintenance work on the brakes yourself if you have the correct information. For example how many of you would think you could carry out work such as replacing your brake pads your self? Not many I can imagine but it's actually a fairly simple procedure to carry out. Below is an easy step by step guide to follow on how to change them your self:

• You need to make sure you have all the required equipment before starting this consists of; hammer, pliers, jack, jack stands, wire brush, screwdriver, high temp lubricant, wrenches, rubber gloves and of course a replacement brake pad.
• Firstly ensure you have exactly the right equipment for your specific model of car, refer to your user manual, before starting the work as it may affect the performance of your car. Also make sure your wearing the correct safety equipment as the brake linings contain asbestos.
• The first thing you need to do is drain around half the brake fluid that is stored in the main cylinder into a sealed container and dispose of it in the proper manner as you can't reuse brake oil.
• Then with a lug wrench loosen the lug bolts but don't remove completely.
• Then one side at a time jack up the vehicle and support the jack with the jack stand, make sure when jacking up the vehicle it is on hard stable ground not grass or dirt.
• Then remove the lug bolts completely and take off the wheels.
• You will then have to remove the callipers of the car, this is when you will have to refer to your manual to discover the type of callipers you have and the correct way of removing them.
• Once this is done you then remove the pad from the calliper, and using the wire brush clean the holding and area around it to remove any dirt or rust. The brakes operate best when clean so use water to wash down this area to stop dust, then you will have to wait for these parts to dry.
• This is when you install the new brake pads some pads have parts that need crimping you can use a hammer for this process, however, if not crimped correctly they can squeal. To prevent squealing you simply rub the high temp grease to the back of the pads, making sure you don't get ANY on the brake pad material itself.
• Once installed you simply replace the calliper to its mounting ensuring all bolts are replaced and pins some retaining pins may need to be tapped in slightly with a hammer. Make sure not to over tighten the bolts (don't use standard hard ware bolts take the old ones into an auto shop to ensure you get the right ones if they need replacing).
• Then all that's left to do is fit the wheels back into position and refill the main oil cylinder with new oil (checking it's the right oil for your car).

If you learn the correct way to do tasks such as this then you don't have to spend time dropping your car off at the garage, then picking it up when the jobs done and in between that trying to find other means of transport. Also there is the fact you will save your self a lot of money as you won't have to pay for the labour costs as well as the parts. Any work you do carry out please ensure it is all completed correctly and check thoroughly the job is up to safety standards before driving the vehicle again.